Table of Supported Gerber Commands M-Codes

Command Description Supported Comment
M00 Program Stop Y If any data is present after an M00 it will be ignored.
M01 Optional Stop Y  
M02
End of Program Y Any data after M02 will be ignored.
M30 End of Tape/ Rewind Y Same as end of program
M50 symbol scale #1 N  
M51 symbol scale #2 N  
M52 symbol scale #3 N  
M53 symbol scale #4 N  
M54 symbol scale #5 N  
M60 Overlap left N No Vape Head Commands are Supported
M61 Overlap top N No Vape Head Commands are Supported
M62 Overlap right N No Vape Head Commands are Supported
M63 Overlap bottom N No Vape Head Commands are Supported
M64 Set Origin to Current Plotter position and continue N  
M65 Move 8" beyond largest X,Y and establish new origin. N  


G-Codes D-Codes M-Codes Mass Parameters Extended Mass Parameters